The Cone Holder End Cap Lanyard is a practical and essential accessory made of metal, designed to prevent the loss of an innovative logistics end cap. This lanyard is sold individually and is used with cone holders purchased after January 17, 2022, which should come with a hole for the lanyard. For cone holders purchased before this date, simple instructions are provided for mounting. This lanyard fits most 18-inch and 28-inch cone holders, making it a versatile and convenient solution for securing end caps and preventing loss during transportation.

Cone Holder End Cap Lanyard

Made Of Metal

Sold Each
LANYARD ONLY - END CAP COMES WITH CONE HOLDER
Used To Prevent The Loss Of An Innovative Logistics End Cap
Cone Holders Purchased After January 17, 2022 Should Come With Hole For Lanyard
For Cone Holders Purchased Before January 17, 2022 Use The Following Instructions To Mount:~Your Current ILP Traffic Cone Holder, Is Mounted On A Cross Member On Your Trailer Or Truck. Once You Identify The Cross Member, You Will Want To Mount The Endcap Lanyard On The Cross Member To The Left Or Right Of The Cone Holder (Your Choice). You Will Need To Drill A 3/16th Hole In The Cross Member Parallel With Where The Cone Holder End Is (The End That You Pull The Cones Off From). Once You Drill The Hole You Will Want To Spread The Round Ring And Feed Through The Hole. After You Have Done This You Can Then Put The End Cap On The Cone Holder Making Sure You Have Depressed The Release Pin And Allowing It To Pop Into The Hole That Was Provided For It.